D88尊龙

你好,歡迎來到濟南D88尊龙環能燃氣發電設備有限公司官方網站!

正確使用天然氣發電機組

來源:http://dgxcbw.comD88尊龙   發布于:2016-11-14

D88尊龙  天然氣發電機組的油箱在長期使用過程中容易損壞的部位是油箱內部的出油管焊接外的外部焊接點。當風部焊接部位出現虛焊或有砂眼時,就會造成機組在運轉中出現轉速不穩或發生停機。那么,使用天然氣發電機組的時候應該注意什么呢?

  Tank of gas generators in the process of long-term use of easily damaged parts is the flowline welding inside the fuel tank external welding point. When the wind of welding parts in virtual welding or when there are sand holes, will cause the unit in operation speed instability or downtime. So, should pay attention to when using natural gas generator set?

D88尊龙  1、天然氣發電機組油箱損壞的原因:造成油箱焊接部位出現虛焊或有砂眼的故障原因是制造廠焊接質量不過關或在運輸中出現較在的震動。

  1, gas generator fuel tank damage reason: cause tank welding parts appear empty welding or have sand holes is the cause of the problem in manufacturing welding quality closes nevertheless, or in the transport in vibration.

D88尊龙  2、油箱損壞后的修理方法:油箱內部出油管焊接部位出現虛焊或有砂眼而漏氣時,應在油箱外部將出油管拆下,然后拆下油箱內部了出油管。出油管損壞后,一般可用銅焊方法焊接。焊接后,應對出油管的密封性進行檢查。

D88尊龙  2, tank damage repair method: after a flowline welding parts in virtual tank welding or have sand holes and air leakage, should be on the outside of the tank out of the tubing will be removed, then remove the fuel tank inside the flowline. Flowline damage, generally available brazing welding method. After welding, sealing inspection flow-line.

D88尊龙  天然氣發電機組的清潔保養對于發電機組的壽命和正常運裝同樣重要。天然氣發電機組維修自理,停止關機的形式是必要的,這樣做是為了排除虛假啟動燃氣輪機。

D88尊龙  Cleaning and maintenance of gas generators for the life of the generator set is as important as the normal shipment. Natural gas generator set maintenance on their own, to stop off in the form of a is necessary, this is done to rule out false start gas turbine.


上一篇:發電機組低壓配電盤的安裝方法
下一篇:沼氣發電機組廠家講解沼氣池發電工藝