D88尊龙

你好,歡迎來到濟南D88尊龙環能燃氣發電設備有限公司官方網站!

正確的解決柴油發電機組漏水問題

來源:http://dgxcbw.com   發布于:2017-01-21

D88尊龙  柴油發電機組的“三漏”故障指:柴油發電機組漏水、漏機油、漏柴油。“漏水”主要表現在淡水泵、水散熱器、水管漏水;“漏機油”主要表現在油底殼墊片漏油;“漏柴油”主要表現在輸油泵和柴油濾清器各接口部位漏柴油。以下是各部件漏水、漏機油、漏柴油的解決方法:

D88尊龙  The "three leakage" fault of diesel generator sets is the leakage, leakage and leakage of diesel engine. "Water Leakage" mainly Water Leakage in fresh water pump, radiator, water pipe; leak oil mainly in the oil pan gasket leakage; leakage of diesel mainly in the oil pump and the interface part of diesel diesel filter leakage. The following are the components of leakage, leakage of oil, diesel leakage solution:

  1、柴油發電機組漏水的處理方法:

D88尊龙  1, diesel generator set leakage treatment method:

D88尊龙  (1)淡水泵漏水解決方法:淡水泵漏水的解決方法若淡水泵監視孔也出現漏水,應從機體上拆下淡水泵并進行分解,然后更換水封。淡水泵上安裝的放水閥由于彈簧損壞而漏水時,可以更換新彈簧或新放水閥。維護人員要在放水閥的彈簧上涂上潤滑脂,以防止彈簧生銹。

  (1) fresh water pump Water Leakage solutions: if the water pump water pump Water Leakage sightglass Water Leakage also appeared on the body, we should remove the water pump and decomposed, and then replace the water. When the water discharge valve installed on the fresh water pump is leaking due to the damage of the spring, the utility model can replace a new spring or a new water discharge valve. Maintenance personnel should be on the drain valve spring coated with grease to prevent the spring rust.

D88尊龙  (2)水散熱器漏水的解決方法:散熱器上、下水室的修理方法檢測出散熱器漏水的部位后,要將漏水的部位清洗干凈,再用金屬刷或刮刀徹底清除金屬漆和鐵銹,然后用焊錫修補。若上、下水室的固定螺釘部位出現較大面積的漏水現象,可以拆下上、下水室,然后重新制作兩個大小適當的水室。裝配上、下水室前要在密封墊的上、下面涂上黏結劑或密封膠,再有螺釘進行固定。

D88尊龙  (2) solution: detect the Water Leakage water radiator radiator parts repair method Water Leakage radiator water room, after cleaning the site will Water Leakage clean, then the metal brush or scraper to completely remove the metallic paint and rust, and then use the soldering repair. If the upper and lower parts of the fixed screw parts of a larger area of water leakage phenomenon, you can remove the upper and lower chamber, and then re production of two appropriate size of the water chamber. Before assembling the upper and lower water chamber, apply the adhesive or sealant on the gasket, and then fix the screws.

  散熱器水管的修理方法在檢測過程上發現散熱器的外層水管破損面積較小時,可使用錫焊進行修復。若破損部位較大,可用尖嘴鉗把破損管的兩邊管頭夾死,使之不漏水。但堵塞水管的數量不宜過多,否則會影響散熱器的散熱效果。若散熱器的內部水管出現破損現象,則尖將上、下水室拆下后,更換或焊補散熱器的內部水管。

D88尊龙  Repair method of radiator pipe outer pipe radiator found damaged area is small in the detection process, can be used to repair soldering. If the damaged parts of large broken pipe clamp available on both sides of the tube head clamp die, so that it is not Water Leakage. However, the number of clogged pipes should not be too much, otherwise it will affect the heat sink. If the radiator of the internal water pipe damage phenomenon, then the tip of the upper and lower water chamber removed, replace or repair the radiator water pipe.

D88尊龙  (3)水管漏水的解決方法水管由于老化而出現漏水時,一是應更換新管。若水管難以買到,可用防水膠布進行纏繞。若由于卡子銹蝕而出現漏水時,可更換卡子或用鐵絲進行纏繞。二是柴油發電機組油底殼墊片漏油的解決方法從油底殼墊片處漏機油時,應更換墊片。

  (3) the method to solve the problem of water leakage of water pipes, due to aging and leakage, one is to replace the new pipe. If it is difficult to buy water available waterproof tape winding. If the clip corrosion and leakage occurs, you can replace the clip or wire winding. Two is the diesel generator set oil sump gasket leakage solution from the oil sump gasket leak oil, should replace the gasket.

D88尊龙  2、更換油底殼墊片的方法如下:用套筒扳手或梅花扳手按對角全部拆下油底殼固定螺釘。拆下后要擦凈油底殼和曲軸箱與墊片接觸的部分,然后涂上密封膠,把墊片安整齊后進行裝配。在裝配過程中要按對角擰上螺釘,不要一個螺釘審批權緊后再擰緊第二個。待所有螺釘擰上后,再逐步將所有螺釘按技術要求擰緊。

D88尊龙  2, the replacement of oil pan gasket method is as follows: the use of socket wrench or spanner wrench all the oil off the bottom of the fixed screws. Remove the oil pan and the contact part between the crankcase and the gasket after removing, and then apply the sealant to the gasket. Screw the screws in the process of assembly, do not tighten the screws and tighten the second screws. After all screws are screwed on, then gradually tighten all screws according to the technical requirements.

  3、柴油發電機組輸油泵和柴油濾清器各接口部位漏柴油的解決方法接口部位漏柴油的故障一般都是由于墊片損壞或回油螺釘松動所造成的,若是由于回油螺釘松動所致,只要維修人員用梅花扳手按規定扭矩將其擰緊即可。

D88尊龙  Fault solution interface part 3, diesel generator fuel pump and fuel filter the interface part of diesel diesel oil leakage leakage is generally because the gasket is damaged or screw loosening caused by the oil, if the oil return screw loosening caused by maintenance personnel, as long as with plum blossom wrench torque required to tighten it.

  客戶的滿意就是對我們的肯定,歡迎您前來選購我公司的產品,我們一直以為您提供產品為己任并一直堅持這樣做。歡迎您的光臨。

  Customer satisfaction is our affirmation, welcome you to come to buy my company's products, we have always thought that you provide products as their own responsibility and has always insisted on doing so. Welcome your presence.


上一篇:燃氣發電機組潤滑方式有幾種
下一篇:沼氣發電機組起勵失敗的緣故為什么會產生噪音