D88尊龙

你好,歡迎來到濟南D88尊龙環能燃氣發電設備有限公司官方網站!

天然氣發電機組啟動停機故障的認識

來源:http://dgxcbw.com   發布于:2016-08-15

  天然氣發電機組啟動停機故障你知道多少呢?下面小編為您講解一下:

D88尊龙  How much do you know about the start-up and shutdown of natural gas generating units? Below small make up for you to explain:

  1、檢查機油壓力是否處在100kpa-500kpa之間。

  1, check whether the oil pressure is between 100kpa-500kpa.

  2、檢查電流表,三相電流偏載不能超過額定電流的10%。

D88尊龙  2, check the current meter, three-phase current bias can not exceed 10% of the rated current.

  3、確認機器正常運轉后,如需帶負荷運行需將空氣開關打至連接位置。

  3, after the confirmation of the normal operation of the machine, such as the need to take the load to hit the air switch to the connection position.

D88尊龙  4、檢查電壓表電壓指示是否在400v,如果搞或低于此數,燃氣發電機組均需通過“轉速微調”手柄調整,順時針旋轉轉速升高,反之,轉速下降。

  4, check the voltage meter to indicate whether the voltage in the 400V, if you engage in or below this number, the gas power generation units are required by the speed adjustment of the handle to adjust the rotation speed, and vice versa, the speed drop.

D88尊龙  5、檢查轉速是否在150轉/分鐘,頻率在50Hz,如果高于或低于此數需通過“轉速微調”手柄調整,順時針旋轉轉速升高,反之,轉速下降。

D88尊龙  5, check whether the speed at 150 RPM / min, frequency in the 50Hz, if higher or lower than the number required by the "speed adjustment" handle adjustment, clockwise rotation speed increases, and vice versa, the speed drop.

  6、運行中檢查各項指標是否正常。

  6, check the operation of the indicators are normal.

  7、機體水溫達到30℃以上方可從“怠速”轉至“運行”狀態。

D88尊龙  7, the body water temperature reached 30 degrees Celsius above can be transferred from the "idle" to "run" state.

  以上介紹的便是關于天然氣發電機組啟動停機故障的知識,相信您對我們的產品已經有了比較深刻的認識,如有任何問題不明白,歡迎來電咨詢,我們竭誠歡迎您的光臨。

  Introduced above is a natural gas power generation unit startup shutdown fault knowledge, I believe you of our products has a more profound understanding of, if any


上一篇:燃氣發電機組的分類
下一篇:沼氣工程怎么選擇適合發電機組